To set up a bidet in a commode, first eliminate the toilet seat. Attach the bidet’s seat to the catch plate, which is a square opening on the toilet. Adjust the bidet’s setting on the commode dish. Screw on the flexible brackets. Then, screw on the nut and also washers. Connect the water supply hose to the bidet’s water inlet. Next, affix the 90-degree elbow end of the tube to the water inlet. Initially, install the brand-new mounting plate. Align the bidet seat with the brand-new installing plate. Make sure it clicks right into place before tightening up the screws. If the system has flexible screws, utilize them. When the mounting plate is seated, install the bidet seat. You may require to make several changes. To inspect if the seat is appropriately lined up, rest on it. If essential, change the hose or the wingnut. Then, affix the tube to the bidet. Make certain that the pipe is connected to the supply of water. Connect the warm water hose to the sink and also make certain the T-connectors fit with the holes on the bidet mounting brace. Then, string the PVC or PEX tubes onto the adapter nut. Once the nut is protected, move the bidet onto the brace. The bidet should click right into place as well as lock into place. As soon as you have set up the bidet, link the water supply. Once the bidet has actually been connected to the warm water supply, the following step is to install the bidet. To do this, you must have an extra PVC or PEX pipe as well as a 3/8th inch T-adapter. Prior to you connect the hose to the adapter, attach the warm water tube to the sink. Once the hose pipe is connected to the warm water supply, thread the adapter nut onto the PVC or PEX tubing. Feed the tubing via the plastic wingnut hole. Put the bidet port right into completion of the cyndrical tube. Press the wingnut right into area, after that press the wingnut into the hose pipe. The t-valve must be placed over the sink to connect the bidet’s supply of water. After affixing the wingnut to the hose, attach the bidet to the installing plate. Make sure that the bidet’s nozzles associate the inlet of the toilet. If necessary, change the hose’s size to prevent it from slipping. If the wingnuts are limited, the bidet is connected. The bidet mounting brace must be affixed to the t-valve on the commode. After that, the water system line ought to be linked to the bidet. If the system already has a water, the wingnut needs to be protected to the bidet. If the installation is finished effectively, it needs to be a straightforward process. If you’re not an electrical expert, follow the instructions on the label.